Optik Researching Machinery Tooling Co., Ltd

www.optik-control.com  e mail. klutch@ms4.hinet.net

Fax 886 2 25067493  Tel:886 2 2507 5367

We have following model for remote control switch

DC-Remote Radio Frequency

 

RM-RF-24VL (24Volt, Remote Radio Frequency Latch type) Red on Blue off

RM-RF-12VL  (12Volt, Remote Radio Frequency Latch type) Red on Blue off

RM-RF-6VL (6Volt, Remote Radio Frequency Latch type) Red on Blue off

  RED on, Blue off

RM-RF-24VM (24Volt, Remote Radio Frequency Moment type) push on release off

RM-RF-12VM  (12Volt, Remote Radio Frequency Moment type) push on release off

RM-RF-6VM (6Volt, Remote Radio Frequency  Moment type) push on release off

 

You might aware of the most difficult of DIY a fog light will be the switch wiring.  Very difficult to make a switch wiring go into the car.  So the remote control will be No.1 choice of DIY.

We have the most simple DIY wiring Remote control.

SPEC -接線簡單遙控配線只有三條電源線

1.  Simple Remote control module -

2. Simple installation –

Red (to Battery) – connect Power in 18Ga, 紅色接正電12V

Yellow (to lamp) – connect Power out 18Ga, 黃色接正電12V

Red (Antenna) – no need to connect to anything (紅色細線為天線不必接)

Black- ground 18Ga. 黑色接負電

 

Beside;

1.      We build the remote control have few style

a.    Latch type – put on.  Remain on till off signal sent.

b.    Moment type – Put on, while release it will stop.  It will be good for direction motor for searching light.  It will stop to the location you want.

c.     Also we may put 2 transmitor with one receiver for one in the car one with driver.

Let me know your request.  I might match what you need.